XP SP3 and driverpaths

Discussion:

(too old to reply)

btm

2008-12-18 14:31:01 UTC

I have XP SP2 images running smoothly and installing drivers through
driverpaths. I created a fresh XP SP3 image and the drivers are not getting
installed, but I notice the drivers are being copied to the destination pc.
Is there some extra step I need to do with XP SP3? Any assistance is
appreciated. Thank you.

FYI - I am using the latest sysprep.

unknown

2008-12-19 09:39:35 UTC

Permalink

No extra steps needed for SP3.... verify that the MDT scripts are
updating sysprep.inf and the devicepath value in the registry
correctly before booting into mini-setup.

Just add a pause to the task sequencer and check manually...

You can also check the ztidrivers.log file for errors...

Regards

Johan Arwidmark
Microsoft MVP - Setup / Deployment
http://www.deployvista.com

On Thu, 18 Dec 2008 06:31:01 -0800, btm

Post by btm
I have XP SP2 images running smoothly and installing drivers through
driverpaths. I created a fresh XP SP3 image and the drivers are not getting
installed, but I notice the drivers are being copied to the destination pc.
Is there some extra step I need to do with XP SP3? Any assistance is
appreciated. Thank you.
FYI - I am using the latest sysprep.

btm

2008-12-22 17:11:01 UTC

Permalink

Thanks Johan,

I got it working. The devicepaths were set properly in the registry. I
added the following to my sysprep.inf. I didn't think I needed to.

UpdateInstalledDrivers = Yes
DriverSigningPolicy = Ignore

Post by unknown
No extra steps needed for SP3.... verify that the MDT scripts are
updating sysprep.inf and the devicepath value in the registry
correctly before booting into mini-setup.
Just add a pause to the task sequencer and check manually...
You can also check the ztidrivers.log file for errors...
Regards
Johan Arwidmark
Microsoft MVP - Setup / Deployment
http://www.deployvista.com
On Thu, 18 Dec 2008 06:31:01 -0800, btm